Emissive device details

Name

 HL BS EPG
The name of the emissive device is generated automatically based on the type and choice of device. After selecting the right type and device, this name can be modified as desired.

System

 HL BS EPG

•      Heating: an emissive device intended for heating the room.

•      Cooling: an emissive device intended for cooling the room.

•      Heating & cooling (4-pipes): an emissive device intended both for heating and cooling the room.

•      Heat & cold (2-pipe, changeover): an emissive device intended both for heating and cooling the room.

•      Variable air volume: an induction system.

Type

 HL BS EPG

§ Heating: [radiator / radiant heating panel  / floor heating / wall heating / CCA in ceiling / 2-pipe fan coil unit / 2-pipe induction unit / radiant tube / open radiant heater / radiant heaters / split unit / local air heating / local electric heating / local gas heating / local oil heating]

§ Cooling: [chilled ceiling / floor cooling / CCA / split unit / 2-pipe fan coil unit / 2-pipe induction unit]

§ Heating and cooling: [climate ceiling / CCA / 4-pipe fan coil unit / 4-pipe induction unit]

Location

 EPG
This location of the emissive device can only be specified for type ‘Radiators’ in the 'Heating' system.

•      For external wall with Rc < 2.5 m2K/W: the radiator is placed against the façade, which has a Rc value less than 2.5 m2K/W;

•      For external wall with Rc >= 2.5 m2K/W: the radiator is placed against the façade, which has a minimum Rc value of 2.5 m2K/W;

•      In front of outer window with radiation shield: the radiator is placed in front of a window with a radiation shield in between;

•      In front of outer window without radiation shield: the radiator is placed in front of a window without a radiation shield in between;

•      In front of inner wall or inner window: the radiator is not placed against the façade or in front of an window;

Location

 EPG
This location of the emissive device can only be specified for type ‘Floor heating’, ‘Wall heating, and ‘Thermal active heating’ in the 'Heating' system.

•      External separation construction Rc < 2.5 m2K/W: the radiator is placed in the external separation construction (ground floor or façade) with a Rc value less than 2.5 m2K/W;

•      External separation construction Rc >= 2.5 m2K/W: the radiator is placed in the external separation construction (ground floor or façade) with a Rc value greater than 2.5 m2K/W;

•      Internal separation construction: the radiator is placed in an internal separation construction (mezzanine floor or interior wall);

Temperature


The temperature for the emissive device can be indicated here. Optionally, one can choose for heating with low temperatures, and/or cooling with high temperatures. This function is intended for low temperature systems, such as CCA.

warning1.png

The option of the low / high temperature distribution effects the selection of the delivery devices. In other words: you can attach link a LT device only to a LT emissive device.

Has exhaust for combustion gases

 EPG
It should be indicated whether the device has an exhaust for combustion gases if the emissive device has been chosen as ‘local gas heating’ or ‘local oil heating’. This parameter is used to determine the flat rate efficiency.

Energy

 EPG
This field indicates whether the emissive device is stoked by gas or oil. It only appears if the delivery device is a radiant heater for high spaces.

Shaft power

 EPG
The shaft power of a single split or multi split cooling device can be stated here. The nominal power is determined based on the specified shaft power in kW.